Rig 2 – Rated to 3600m – New 2006
Equipment Inventory and Specifications
Depth Rating: 3600 m
KB to Ground: 4.95 m
Move Loads: 20 Summer / 21 Winter (Loads may vary with tubular requirements)
Rig Mast / Substructure Ratings
Model: ZK 30 158,000 daN Telescopic Double
Mast: Maximum static hook load rating 158,000 daN 112 mph wind capacity with no setback and no hook load
84 mph wind capacity with full setback and no hook load
Substructure: Step down design
Rotary support capacity: 158,000 daN
Setback capacity: 120,000 daN
Depth Rating: 3,600 meters
ALL above ratings at 100% manufacturer - Company policy sets ratings @ 85%
Pressure Ratings
F-1000 Allowable Pressures:
- 165 mm - 15,000 kPa
- 159 mm - 16,500 kPa
- 152 mm - 17,500 kPa
- 140 mm - 21,000 kPa
- 127 mm - 25,500 kPa
PUMP IS EQUIPPED WITH 152 MM EQUIPMENT ONLY
Circulating system rated at 35,000 kPa
Mast
Model JJ15831D, 31m Telescopic Double
Effective height 31m
Max hook load 158,000 daN
Racking board height above floor 17.4m
Set back capacity 4,000 m 101 mm drill pipe, 20 joints
159 mm drill collars
Crown Block model TC 160-5-910
5 x 910 mm 28.5 mm grooved sheaves
Fold up racking board
35,000 kPa rated circulating system
51 mm secondary circulating riser
Rear egress escape buggy
Climb assist device
Secondary fall arrest system
Substructure
Model DZ-160-4.5
Max set back 120,000 daN
Capacity - 4,000 m 101 mm drill pipe 20 joints 159 mm drill collars
Floor Height 4.5 m
Ground to bottom of rotary beam 3.52 m
Floor area 7 m wide x 5.76 m long
Pipe bottom bird baths
BOP Hydraulic lift system
ZP175 17 ½" rotary table rated at 160,000 daN
BOPS
1 - 279mm, 21,000 KPa W.P. HEC SPHERICAL BOP Nace Trim
1 - 279mm Shaffco NRS x CSO Single Gate 21,000 kPa ram body with 101 mm ram blocks
1 - 279mm Shaffco NRS x CSO Single Gate 21,000 kPa ram body with blind ram blocks
1 - 279mm x 21,000 kPa working spool with 2, 76 mm x 21,000 kPa side outlets.
Manual Valves & HCR
2 - 50 mm Kill line valves with Check Valve
76 mm HCR valve and manual valve
11 valve manifold, 76 mm gut x 51 mm wing valves, to conform to ERCB standards with 2 chokes
All Nace trim
Drawworks
Model JC30 rated 750 HP Powered by a 630 HP Cummins QSX15 w/ Allison S6610H Transmission
JFD 130 right angle gear box
29 mm grooved circulating drum with closed loop glycol system
267 mm x 1,270 mm brake flanges
324 WCDB Eaton auxiliary brake with closed loop glycol system shared with circulating drum
Rotary table brake
8,000 Lb. tugger winch on D.H. side of drawworks skid
5,000 Lb. tugger winch on M.T. side of drawworks skid
Survey winch with .092 survey line
Drill String
Hydraulic catwalk with manifold shack with one 79 mm ID choke line and one 101 mm OD degasser line
3 Hydraulic pipe tubs, 4 transport tubs
167 joints of 101 mm - 4 FH 14.00 lb. X95 with internal coating and hardbanding
159 joints of 101 mm - 4 FH 15.70 lb. X95 with internal coating and hardbanding
20 joints of 159 mm - 4 ½ XH drill collars
2 Joints of 203 mm - 6 5/8 REG drill collars
HWDP as required (rental item)
Pipe count may vary according to drilling program
More pipe available on request
Mud Tanks
2 x 50 m3 with 7 usable compartments including trip tank and pill tank
Shaker tank, 2 x settling tanks, 2 x suction tanks and pill tank
All rigged with bottom guns and dump gates
Sand trap
4 - 7.5 hp agitators in tank
2 - 50 hp 5x6 Mission mud mixers
30" De-gasser to conform to ERCB standards
Pumphouses
3.75 m wide building
2 - RG F-1000 mud pumps equipped with 152 mm heads & liners
Equipped with a mechanical driven precharge
Powered by a QSK 23 - 1050 hp Cummins engine
35,000 kPa rated circulating system
76 mm pressure relief system
Shale Shakers
2 - MI-Swaco Mongoose
Light Plants
2 - 400 KW generators
Powered by Cummins QSX 15
1 - 5 station 21,000 kpa, 360 L accumulator, 8 - 44 L precharge
Bottles with PLC remote control in doghouse, air back-up
Plumbed for Nitrogen and N2 installed
D.H. / W.T.
65 m3 water storage
17,500 L Fuel tank
2 fuel pumps
2 water pumps
Traveling Equipment
SL160 Swivel 158,000 daN
Hydraulic Kelly Spinner
YG 160 158,000 daN block / hook w / 4 x 915 mm sheaves
4 ¼" square Kelly bar
1 - Spinmaster 550 Pipe spinner
Boiler
125 HP Williams & Davis Boiler
20 m3 water tank
6,000 L fuel tank
Topdrive
Can be installed (availability may vary)
Miscellaneous
Safety & first aid equipment as per industry standards
Complete set of hand tools
Mounted wash gun with hose reel
Tarp style prefabs
8 - 8 x 20 mats, 10 - 4 x 12 mats
Inventory is subject to change without notice.
