Rig 1 – Rated to 3200m – New 2006

Rig Footprint (pdf document)

Rig Inventory (pdf document)

Equipment Inventory and Specifications

Depth Rating: 3200 m
KB to Ground: 4.95 m
Move Loads:17 Summer / 18 Winter (Loads may vary with tubular requirements)

Rig Mast / Substructure Ratings

Model: ZK 3,200 m Telescopic Double
Mast: Maximum static hook load rating 135,000 daN 112 mph wind capacity with no setback and no hook load
84 mph wind capacity with full setback and no hook load
Substructure: Step down design
Rotary support capacity: 125,000 daN
Setback capacity: 100,000 daN
Depth Rating: 3,200 meters
ALL above ratings at 100% manufacturer - Company policy sets ratings @ 85%

Pressure Ratings

F-1000 Allowable Pressures:

  • 165 mm - 15,000 kPa
  • 159 mm - 16,500 kPa
  • 152 mm - 17,500 kPa
  • 140 mm - 21,000 kPa
  • 127 mm - 25,500 kPa

PUMP IS EQUIPPED WITH 152 MM EQUIPMENT ONLY
Circulating system rated at 35,000 kPa

Mast

Model JJ135D 31m Telescopic Double
Effective height 31m
Max hook load 135,000 daN
Racking board height above floor 17.4m
Set back capacity 3,500 m 101 mm drill pipe, 20 joints
159 mm drill collars
Crown Block model TC 135, rated at 135,000 daN
5 x 760 mm 1 1/8" grooved sheaves
Fold up racking board
35,000 kPa rated circulating system
51 mm secondary circulating riser
Rear egress escape buggy
Climb assist device
Secondary fall arrest system

Substructure

Model DZ 135 4.5
Max set back 100,000 daN
Capacity - 3,500 m 101 mm drill pipe 20 joints 159 mm drill collars
Floor Height 4.5 m
Ground to bottom of rotary beam 3.52 m
Floor area 7 m wide x 5.76 m long
Pipe bottom bird baths
BOP Hydraulic lift system
ZP 175 17 ½" rotary table rated at 160,000 daN

BOPS

228 mm x 21,000 kPa Nace Trim
1 - Annular FH23-21 (Annular Shaffer Element)
1 - FZ23-21 228 mm 21,000 kPa ram body with 101 mm ram blocks
1 - FZ23-21 228 mm 21,000 kPa ram body with blind ram blocks
1 - 228 mm x 21,000 kPa working spool with 2, 76 mm x 21,000 kPa side outlets.

Manual Valves & HCR

2 - 50 mm Kill line valves with Check Valve
76 mm HCR valve and manual valve
11 valve manifold, 76 mm gut x 51 mm wing valves, to conform to ERCB standards with 2 chokes
All Nace trim

Drawworks

Model JC20 rated 550 HP powered by a 630 HP Cummins QSX15 w/ Allison S6610H Transmission
JFD 130 right angle gear box
28.5 mm grooved circulating drum with closed loop glycol system
310 mm x 1,067 mm brake flanges
224 Eaton auxiliary brake with closed loop glycol system shared with circulating drum
Rotary table brake
8,000 Lb. tugger winch on mud tank side/boom line compatible
8,000 Lb. tugger winch on doghouse side
Survey winch with .092 survey line

Drill String

Hydraulic skate catwalk with manifold shack with one 79 mm ID choke line and one 101 mm OD degasser line
3 Hydraulic pipe tubs, 4 transport tubs (forklift accessible)
240 joints of 101 mm, 14.0#/ft - 4 FH X95 with internal coating and hard banding
20 joints of 159 mm - 4 ½ XH drill collars
2 Joints of 203 mm - 6 5/8 REG drill collars
HWDP as required (rental item)
Pipe count may vary according to drilling program
More pipe available on request

Mud Tanks

72 m3 with 5 usable compartments including trip tank and pill tank
Shaker tank, settling tank, suction tank and pill tank
All rigged with bottom guns and dump gates
Sand trap
4 - 7.5 hp agitators in tank
2 - 50 hp 5x6 Victory mud mixers
762mm De-gasser to conform to ERCB standards

Pumphouses

3.75 m wide building
RG F-1300 mud pump equipped with 152 mm heads & liners
Equipped with a mechanical driven precharge
Powered by a QSK 23 - 1050 hp Cummins engine
35,000 kPa rated circulating system
76 mm pressure relief system

Shale Shakers

1 - DFTS Linear Motion

Light Plants

2 - 400 KW generators
Powered by Cummins QSX 15
1 - 5 station 21,000 kpa, 360 L accumulator, 8 - 44 L precharge
Bottles with PLC remote control in doghouse, air back-up
Plumbed for Nitrogen and N2 installed

D.H. / W.T.

65 m3 water storage
18,000 L Fuel tank
2 fuel pumps
2 water pumps

Traveling Equipment

SL160 Swivel 160,000 daN
Hydraulic Kelly Spinner
YG 135C 135,000 daN block / hook w / 4 x 762 mm sheaves
4 ¼" square Kelly bar
1 - 550 Pipe spinner

Boiler

125 HP Williams & Davis Boiler
20 m3 water tank
6,000 L fuel tank

Topdrive

Can be installed (availability may vary)

Miscellaneous

Safety & first aid equipment as per industry standards
Complete set of hand tools
Mounted wash gun with hose reel
Tarp style prefabs
8 - 8 x 20 mats, 7 - 4 x 12 mats

Inventory is subject to change without notice.